Cura generated code on CR-10; heats only bed and not nozzle; doesn't print - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Using Cura, I select my printer, CR-10 (1.1.6), the correct flavor, Merlin, verify that I have a temperature of 205 for the nozzle and 60 for the bed, and slice the file and save as gcode. When I attempt to print, the nozzle will heat correctly, but the temperature set point for the bed remains a

4.11 adds unknown bed start code - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

UltiMaker Cura

Nozzle randomly moves to the middle of the bed halfway into the print after every layer - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Creality CR 10 SE 3D Printer with Removable Bed and Auto Leveling, Effective Model Cooling Fan and Sprite Direct Extrusion, 600mm/s High-Speed Printing : Industrial & Scientific

Cura settings for Reality Cr-10 V3 - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Print is not centered correctly on Bed - Improve your 3D prints - UltiMaker Community of 3D Printing Experts

print starts at negative Z ?? Cura 5.3 crashes bed when the model starts on support - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

creality ender 3 - Cura variables and initial G-code commands - 3D Printing Stack Exchange

Cura Wierdness - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

I can't make clean holes when slicing with cura - UltiMaker 3D printers - UltiMaker Community of 3D Printing Experts